Configuring your router
In order to properly configure your router to work with Morpheus, use following directions below that corresponds with your routers manufacturer. If there are no directions for your manufacturer, try asking for help on the Morpheus Forum (http://www.morpheusforum.com) or go to your manufacturers website.

Configuring UPnP with a Linksys router

1. First verify the latest firmware version is installed on your router. If you are not sure please visit the Linksys site at www.linksys.com.

2. Open a web browser and enter the IP address of your router in the address bar.(The default IP address is 192.168.1.1) Click Go or hit the [Enter] key.

3. A "User Name" and "Password" prompt will appear, leave the "User Name" blank and input the routers password (the default password is admin) and click OK.

4. After entering the routers password, the "Setup" page should appear, if there is Password tab, please click on it. If not click on the Administration tab.

5. When the page loads, make sure that "UPnP" is Enabled, if it is not, click on Enabled, then click Apply or Save Settings.

Configuring UPnP with a D-Link router

1. First verify the latest firmware version is installed on your router. If you are not sure please visit D-Link's site at www.dlink.com.

2. Open a web browser and enter the IP address of your router in the address bar.(The default IP address is 192.168.0.1) Click Go or hit the [Enter] key.

3. The default username is admin (all lower case) and the default password is blank (nothing). Click OK.

4. Click the Tools tab then click Misc. to the left.

5. Under the UPnP Settings section, select Enabled using the radio buttons to enable UPnP on the wireless router.

6. Click Apply and then click Continue to save the new settings.

Configuring UPnP with a NETGEAR router

1. First verify the latest firmware version is installed on your router. If you are not sure please visit NETGEAR's site at www.netgear.com.

2. Open a web browser and enter the IP address of your router in the address bar.(The default IP address is 192.168.1.1) Click Go or hit the [Enter] key.

3. When a connection is established, you will be prompted to enter your user name and password. The default username is admin and the default password is "password" or "1234" depending on your router model. Click OK.

4. Click the UPnP on the left menu.

5. In the UPnP menu, check the checkbox Turn UPnP On to enable UPnP on the wireless router

6 . Click Apply at the bottom of the page to save the change.

Configuring UPnP with a Belkin router

1. First verify the latest firmware version is installed on your router. If you are not sure please visit Belkin's site at www.belkin.com

2. Open a web browser and enter the IP address of your router in the address bar.(The default IP address is 192.168.2.1) Click Go or hit the [Enter] key.

3. When a connection is established, you will be prompted to enter your password. The default password is blank (nothing). Click Submit.

4. Click the System Settings on the left menu.

5. In the UPNP Enabling: menu, select Enable using the radio buttons to enable UPnP on the wireless router (see the following illustration).

6. Click Apply Changes at the bottom of the page to save the change.